Battery Monitor Systems

Measures battery volts, amps, and amp-hours with 7 data monitoring functions

Complete information, full specifications, theory of operation, and manuals can be downloaded from the TriMetric website.

All of these items may be purchased online from our webstore.

TM 2020 TriMetric Monitor

Note - This is very similar in function to the Xantrex Link 10/Emeter. It is basically the same as the Xantrex TM500 in a different color and cheaper. We have sold more TM2020 units than all other battery monitors combined, and have never heard of a complaint or failure.

TM 2020 & TM 2020 mounted in Wiremold double-gang box

TM-2020

The Trimetric 2020 battery system monitor shows battery voltage, amps, amp-hours into the battery, battery percent full, days since fully charged, days since equalized, and minimum and maximum battery volts.

Requires Shunt 500 or 100.

TM 48A Adaptor for 48 volt battery systems

Options and accessories for TriMetric: 500 and 100 amp shunts, TM48A adaptor, meter to shunt cable.

TM-48A

48 volt adapter and lightning protector. This allow the Trimetric 2020 to operate with 48 volt battery systems adds lighting protection. The adaptor goes between the meter and the shunt.

Shunts for Trimetric, Trace or any other monitor or controller that requires a shunt.

Manufactured by Deltec. Deltec DC Ammeter shunts are designed to provide the highest Quality Performance possible while maintaining their rugged construction characteristics. The shunts are designed and calibrated at the factory to have standard accuracy of ± 1/4%.

MKB-50-500: 500 amp, 50 mv (400 amps maximum)

500 amp-50 mV Shunt: For systems with maximum current 400 amps continuous with no overloads, or 300 amps continuous with up to 5 minute overloads to 500 amps max. It allows amp readings as low as 0.1 amps. They are suitable for virtually all systems with moderate or large sized inverters. Size 31/4 by 13/4 inch base, 17/8 inches in height.

Deltec MKB 500 amp shunt.
3.25" L x 1.75" W x 1.75" H
3/8"-16 terminals.

MKA-100-100: 100 amp 100 mv shunt

100 amp-100 mV Shunt: For systems with maximum current 75 amps continuous with no overloads, or 50 amps continuous with overload to 100 amps for 8 seconds max. These are suitable for small systems, or for most applications where you want to measure only solar or wind input current. It allows "amps" readings as low as 0.01 amps.

Deltec MKA 100 amp shunt.
2" L x 1.25" W x 1.7" H.
1/4"-28 terminals.

Accessories for TriMetric

Wiremold box, as shown above, for mounting TriMetric.

Wiremold ^TM "Double Gang" Box #2348-2:
The TriMetric may be mounted in a standard "double gang" electrical box mounted 90 degrees from the usual position, or may be mounted on a flat surface in this attractive, cream colored enclosure. It also accommodates the 48V adapter.

Size: 4.75" x 5" x 2" deep